31
2024
-
10
How to solve the jump brush?
①. The whole bracket of the wiper can be replaced by 180 degrees (some brackets can be replaced); ②. You can take out the wiper leather strip from the bracket and replace it with two ends and then put it into the bracket (the bracket does not move, and the leather strip is changed 180 degrees);
①. The whole bracket of the wiper can be replaced by 180 degrees (some brackets can be replaced);
②. You can take out the wiper leather strip from the bracket and replace it with two ends and then put it into the bracket (the bracket does not move, and the leather strip is changed 180 degrees);
③. To adjust the pressure of the wiper arm on the glass (the pressure of the swing arm spring), just bend the swing arm by hand; (it is also a pressure problem that does not completely scratch the glass)
④. If the above three methods fail, it must be that the angle of the wiper arm is wrong, causing the angle of the wiper blade and the windshield to change when in contact. The main reason is that the wiper blade is not as vertical as possible. Just use pliers to clamp the front end of the wiper arm (hook for the wiper) and twist it. The wiper will twist counterclockwise when it jumps upward, and the wiper will twist clockwise when it jumps back. Until it does not jump and keep the wiper strip vertical to the glass surface.
More information
2024-10-31
2024-10-31
2024-10-31
2024-10-31
Add
No.15, Standard Factory C, Jiu Long Garden Avenue, Jiu Long Po District, Chong Qing City
Copyright Chongqing Cabella Electromechanical Co.,Ltd All Rights Reserved.
Website：300.cn jinzhou.300.cn | SEO | Privacy Policy